Effect of Citrate-Based Bath pH on Properties of Electrodeposited Cu-Zn Coating on an Aluminum Substrate

被引:0
作者
Ozdemir, Rasim [1 ]
Unal, Ersin [2 ]
Karahan, IsmaIl Hakki [3 ]
机构
[1] Kilis 7 Aralik Univ, Vocat Sch Tech Sci, TR-79000 Kilis, Turkiye
[2] Osmaniye Korkut Ata Univ, Fac Engn & Nat Sci, Dept Mech Engn, TR-80000 Osmaniye, Turkiye
[3] Univ Mustafa Kemal, Fac Arts & Sci, Dept Phys, TR-31040 Hatay, Turkiye
来源
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE | 2024年 / 55卷 / 10期
关键词
ZINC ELECTRODEPOSITION; ELECTRICAL-RESISTIVITY; NANOCOMPOSITE COATINGS; COPPER-ZINC; ALLOY; FABRICATION; CORROSION; FILMS; TIN; MICROSTRUCTURE;
D O I
10.1007/s11661-024-07524-3
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
In this study, Cu-Zn alloys were deposited in citrate-based electrolytes on aluminum substrate by electrodeposition method. The effect of bath pH variation on the properties of the obtained Cu-Zn alloy coatings was investigated. The electrochemical behavior of the citrate-based baths and the crystalline structure, surface morphology and elemental content, electrical resistivity and thermal behavior of the alloy coatings were analyzed. According to the results of cyclic voltammetry (CV) analysis, increasing bath pH caused a negative shift in the cathodic deposition potential. In addition, the anodic dissolution peaks first shifted to the positive side with increasing pH and then shifted back to the negative direction. According to the results of XRD analysis, the phase structure of Cu-Zn alloys generally consists of alpha and beta ' phases, but according to differential scanning calorimeter (DSC) analysis, it is possible that there is a gamma phase in the structure in addition to these phases. In addition, pH increase (4.5 to 6.5) caused a relative increase in crystal grain size (similar to 14 to similar to 25 nm). The Zn content of Cu-Zn coatings first increased (similar to pct 15 to similar to pct 55) with pH increase, then followed a horizontal trend (similar to pct 55 to similar to pct 59) with further pH increase and then exhibited a slight decreasing trend (similar to pct 59 to similar to pct 52). The pH increase significantly affected the surface morphology of the coatings and denser coatings were obtained with increasing pH. While the electrical resistivity of Cu-Zn coatings first increased (0.0408 to 0.0696 mu Omega cm for 297 K) with increasing pH, it tended to decrease (0.0696 to 0.0479 mu Omega cm for 297 K) again at higher pH values. In addition, the electrical resistivity of the coatings increased with increasing measurement temperature. According to DSC analysis of the coatings, endothermic peaks were obtained, possibly representing the transformation from gamma to beta ' phase. [GRAPHICS] . (c) The Author(s) 2024
引用
收藏
页码:3937 / 3955
页数:19
相关论文
共 81 条
  • [1] Free-Cyanide Synthesis and Characterization of Cu–Zn Alloy by an Electrodeposition-Annealing Route
    Abacha I.
    Boukhrissa S.
    [J]. Surface Engineering and Applied Electrochemistry, 2018, 54 (5) : 459 - 467
  • [2] Electrodeposition of Ni-W/PTFE Nanocomposite Coating and Investigation of Its Corrosion Resistance and Microhardness
    Abdolmaleki, Mehdi
    Ghamari, Katayon
    Ahmadiyeh, Somayeh
    Azadi, Bahareh
    Hanifehpour, Younes
    Allahgholipour, Gholam Reza
    Hosseini, Javad
    Farhood, Amir Hassan Shafi
    [J]. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2024, 55 (01): : 352 - 359
  • [3] KINETIC STUDY OF BETA TO ALPHA MASSIVE TRANSFORMATION IN A CU-ZN ALLOY
    AYERS, JD
    MASSALSKI, TB
    [J]. METALLURGICAL TRANSACTIONS, 1972, 3 (12): : 3185 - 3190
  • [4] Optimization of plating process and corrosion behavior of nanocrystalline Ni-Mo coatings on pure aluminum
    Bao, Qianlian
    Zheng, Wenxin
    Chen, Lian
    Xu, Zhenkai
    Han, Jingliang
    Zhu, Chengfei
    [J]. COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 2022, 636
  • [5] The use of X-ray diffraction peak profile analysis to determine the structural parameters of cobalt ferrite nanoparticles using Debye-Scherrer, Williamson-Hall, Halder-Wagner and Size-strain plot: Different precipitating agent approach
    Basak, Munmun
    Rahman, Md Lutfor
    Ahmed, Md Farid
    Biswas, Bristy
    Sharmin, Nahid
    [J]. JOURNAL OF ALLOYS AND COMPOUNDS, 2022, 895
  • [6] Comparison of electrodeposited copper-zinc alloys prepared individually and combinatorially
    Beattie, SD
    Dahn, JR
    [J]. JOURNAL OF THE ELECTROCHEMICAL SOCIETY, 2003, 150 (11) : C802 - C806
  • [7] Bedir M, 2015, INT J ELECTROCHEM SC, V10, P4513
  • [8] Estimation of lattice strain in ZnO nanoparticles: X-ray peak profile analysis
    Bindu, P.
    Thomas, Sabu
    [J]. JOURNAL OF THEORETICAL AND APPLIED PHYSICS, 2014, 8 (04) : 123 - 134
  • [9] Boukhoubza I., 2019, Journal of Physics: Conference Series, V1292, DOI 10.1088/1742-6596/1292/1/012011
  • [10] Callister W.D., 2015, MAT SCI ENG, V9th ed.