Analysis of influential factors on the seismic behavior of PC columns connected by steel-concrete composite joints

被引：0
|
作者：
Du Y.-F. [1 ,2 ]
Li H. [1 ]
Han B. [1 ]
Li F.-Y. [1 ]
机构：
[1] Institute of Earthquake Protection and Disaster Mitigation, Lanzhou University of Technology, Lanzhou, 730050, Gansu
[2] International Research Base on Seismic Mitigation and Isolation of Gansu Province, Lanzhou University of Technology, Lanzhou, 730050, Gansu
来源：
Gongcheng Lixue/Engineering Mechanics | 2020年 / 37卷 / 06期
关键词：
Numerical simulation; PC column; Quasi-static test; Seismic behavior; Steel-concrete composite joint;
D O I：
10.6052/j.issn.1000-4750.2019.09.0530
中图分类号：
学科分类号：
摘要：
One cast-in-place column specimen and two pre-cast concrete PC column specimens were tested under low-cyclic reversed loading to study the seismic behavior of the PC columns connected by steel-concrete composite joints. The differences in the seismic behavior of the PC column and the cast-in-place column, and the effects of the axial compression ratio on the seismic behavior of PC columns were investigated. A finite element model was established to simulate the hysteretic behavior of the PC columns under lateral repeated loads in ABAQUS. The numerical results agreed well with the test results. By expanding the range of the analysis factors, the influence of various factors on the seismic behavior of PC columns was further analyzed by using the finite element model. The results show that the hysteretic behavior of PC columns is similar to that of cast-in-place columns. The axial compression ratio and the shear span ratio are important factors that affect the seismic behavior of the PC columns. The lateral strength and lateral stiffness of a PC column increase and the deformation and the energy dissipation capacity deteriorate with the increase in the axial compression ratio and with the decrease in the shear span ratio. Increasing the stirrup ratio or the reinforcement ratio will improve the seismic behavior of the PC columns. Changing the parameters of the joints has little influence on the seismic behavior of the PC columns. © 2020, Engineering Mechanics Press. All right reserved.
引用
收藏
页码：110 / 121and154
相关论文
共 27 条
  • [11] Zhao Dongfu, Wang Lei, Finite element analysis of seismic behavior of prefabricated lateral resistant lattice column, Industrial Construction, 48, 11, pp. 161-167, (2018)
  • [12] Nzabonimpa J D, Hong W K., Structural performance of detachable precast composite column joints with mechanical metal plates, Engineering Structures, 160, pp. 439-460, (2018)
  • [13] Liu Y., Finite element analysis on the seismic behavior of side joint of prefabricated cage system in prefabricated concrete frame, Frontiers of Structural and Civil Engineering, 13, 5, pp. 1095-1104, (2019)
  • [14] Deng Mingke, Ma Fudong, Ye Wang, Et al., Experimental study on aseismic behavior of locally used HDC assembled frame beam-column joints, Engineering Mechanics, 36, 9, pp. 68-78, (2019)
  • [15] Rave-Arango Jose F, Blandon Carlos A, Restrepo Jose I, Et al., Seismic performance of precast concrete column-to- column lap-splice connections, Engineering Structures, 172, pp. 687-699, (2018)
  • [16] ABAQUS theory manual, (2006)
  • [17] Kremmyda G D, Fahjan Y M, Tsoukantas S G., Nonlinear FE analysis of precast RC pinned beam-to-column connections under monotonic and cyclic shear loading, Bulletin of Earthquake Engineering, 12, 4, pp. 1615-1638, (2014)
  • [18] Zhao Guifeng, Li Yaoliang, Zhang Meng, Et al., Numerical simulation research on hysteresis performance of corroded reinforced concrete frame columns, World Earthquake Engineering, 30, 2, pp. 71-79, (2014)
  • [19] Clough R W., Effect of stiffness degradation on earthquake ductility requirements, (1966)
  • [20] Qu Z., Predicting nonlinear response of an RC bridge pier subject to shake table motions, Proc. 9th International Conference on Urban Earthquake Engineering (9CUEE), pp. 1717-1724, (2012)
123