Physical-chemical and pyrometallurgical estimation of processing of complex ores with extraction of iron, vanadium, titanium

被引：2

作者：

Dmitriev A.N. ^{[1
]}

Vitkina G.Yu. ^{[1
]}

Alektorov R.V. ^{[1
]}

Vyaznikova E.A. ^{[1
]}

机构：

[1] Institute of Metallurgy of the Ural Branch of the Russian Academy of Sciences, 101 Amundsen St, Ekaterinburg

来源：

Dmitriev, A.N. (andrey.dmitriev@mail.ru) | 1600年 / Trans Tech Publications Ltd卷 / 407期

关键词：

Blast furnace smelting; Characteristics; Metallization; Pellets; Phase composition; Titanium; Vanadium;

D O I：

10.4028/www.scientific.net/DDF.407.41

中图分类号：

学科分类号：

摘要：

The metallurgical characteristics of pellets (reducibility, strength after reaction, softening start and end temperatures), phase composition (X-ray phase analysis), and porosity were studied. Blast furnace smelting parameters were calculated using laboratory pellets with different basicities and degrees of metallization. Pellets were obtained from complex titanium-magnetite ores. The vanadium extraction of this ore into metal did not exceed 10% during smelting of metallized pellets in an arc steelmaking furnace, but special techniques could raise this to 85%. According to calculations from the Institute of Metallurgy of the Ural Branch of the Russian Academy of Sciences (IMET UB RAS), vanadium extraction up to 80-90% can be achieved by using high-base and partially metallized pellets. The influence of changes in the composition and metallurgical characteristics of titanomagnetite pellets with increasing basicity (especially relative to strength after reduction) should be taken into account. © 2021 Trans Tech Publications Ltd, Switzerland.

引用

页码：41 / 50

页数：9

共 6 条

[1]

Dmitriev A.N., Current state, prospects and development of the base of titanium-containing ores of the Urals, Ferrous Metallurgy, 12, pp. 36-40, (2015)

[2]

Kopot N.N., Development and improvement of the technology for the production of pellets and their metallization in a shaftfurnace: by the example of the HIL-III installation of JSC Lebedinsky GOK, (2005)

[3]

Dmitriev A.N., Vitkina G.Yu., Chesnokov Yu.A., Methodical basis of investigation of influence of the iron ore materials and coke metallurgical characteristics on the blast furnace smelting efficiency, Advanced Materials Research, 602-604, pp. 365-375, (2013)

[4]

Dmitriev A.N., Chesnokov Yu.A., Arzhadeeva G.Yu., The coke and iron ore materials kinetic characteristics and quantitative indicators of blast furnace process, Defect and Diffusion Forum, 322, pp. 87-106, (2012)

[5]

Chentsov A.V., Chesnokov Yu.A., Shavrin S.V., Balance logic-statistical model of the blast furnace process, (2003)

[6]

Lazutkin S.S., Research and development of a new technology for the processing of pellets from the Kachkanarsky GOK, (2000)

← 1 →