Pilot protection method for multi terminal flexible DC lines based on current traveling wave mutation characteristics

被引：0

作者：

Guo J. ^{[1
]}

Fan Y. ^{[1
]}

Hou J. ^{[1
]}

机构：

[1] School of Electrical Engineering, Xinjiang University, Urumqi

来源：

Dianli Xitong Baohu yu Kongzhi/Power System Protection and Control | 2023年 / 51卷 / 18期

关键词：

high resistance ground fault; least square method; multi-terminal flexible DC transmission; pilot protection;

D O I：

10.19783/j.cnki.pspc.230217

中图分类号：

学科分类号：

摘要：

Traveling wave protection is widely used as the main protection in flexible DC transmission lines. However, as a single-ended protection, traveling wave protection has limited ability to withstand transition resistance. Therefore, given the problem that there is diminished sensitivity in fault detection for main protection of flexible DC transmission lines caused by high-impedance grounding faults, a fast pilot protection method is proposed based on the abrupt change characteristics of current traveling waves. First, by analyzing the propagation process of the line-mode current traveling wave on the line, the mutation characteristics of the line-mode current traveling wave at both ends of the line during internal and external faults are derived. Second, the least square method is used to fit the line-mode current traveling waves to construct main criterion of protection. The it combines with the starting and pole-selection criteria to form the pilot protection method. Finally, a four-terminal flexible DC power grid model is built on the PSCAD/EMTDC platform for simulation verification. Simulation results show that the proposed protection method can quickly and reliably identify faults both within and outside the zone, and withstand 300 Ω transitional resistance and 30 dB Gaussian white noise. It has low requirement on sampling frequency and communication. © 2023 Power System Protection and Control Press. All rights reserved.

引用

页码：31 / 42

页数：11

共 28 条

[1]

DU Yongan, DU Liyan, XU Yan, Frequency regulation for PV generation connected to an interconnection area by VSC-HVDC, Power System Protection and Control, 49, 6, pp. 1-9, (2021)

[2]

ZHENG Wei, GUO Jianbao, YANG Guangyuan, Et al., A practical model suitable for DC fault simulation of a multi terminal DC transmission system, Power System Protection and Control, 50, 12, pp. 180-187, (2022)

[3]

MA Wenzhong, GULIPALI Sailijiang, ZHOU Guanyu, Et al., Active/passive switching control strategy for MMC- HVDC connected to an island power grid, Power System Protection and Control, 48, 21, pp. 157-165, (2020)

[4]

GUO Xianshan, ZHOU Yang, MEI Nian, Et al., Construction and characteristic analysis of Zhangbei flexible DC grid, Power System Technology, 42, 11, pp. 3698-3707, (2018)

[5]

WANG Chen, WEI Ziwen, WANG Yi, Et al., A novel MMC parallel dual-port submodule and its three-stage fault current blocking mechanism, Power System Protection and Control, 51, 1, pp. 81-92, (2023)

[6]

YOU Guangzeng, LI Huarui, LI Changgang, Et al., Coordinative frequency control of multi HVDC links in sending-end power grid considering over-frequency protection of wind power generation, Electric Power, 54, 5, pp. 83-90, (2021)

[7]

ZHANG Chengquan, ZOU Guibin, ZHANG Shuo, Et al., A current flow controller suitable for MTDC grids, Power System Protection and Control, 50, 20, pp. 32-40, (2022)

[8]

SHAN Jieshan, REN Min, TIAN Xincui, Et al., Analysis of grounding fault current at the AC valve side of an MMC converter station, Power System Protection and Control, 50, 19, pp. 36-48, (2022)

[9]

ZHENG Wei, ZHANG Nan, YANG Guangyuan, Comparative and improvement investigation on the DC transmission line traveling wave protections of Siemens and ABB, Power System Protection and Control, 43, 24, pp. 149-154, (2015)

[10]

MUNIAPPAN M., A comprehensive review of DC fault protection methods in HVDC transmission systems, Protection and Control of Modern Power Systems, 6, 1, pp. 1-20, (2021)

← 1 2 3 →