A trial three-phase two-pole six-slot small concentrated-winding squirrel-cage induction motor and its basic characteristics

被引：0
作者：
Watanabe N. [1 ]
Nakamura M. [1 ]
Hirotsuka I. [1 ]
机构：
[1] Chubu University, 1200, Matsumoto, Kasugai, Aichi
来源：
IEEJ Transactions on Industry Applications | 2020年 / 140卷 / 08期
关键词：
Concentrated winding; Induction motor; Iron shape; Magnet field analysis; Measurement; Trial machine;
D O I：
10.1541/ieejias.140.571
中图分类号：
学科分类号：
摘要：
With the increase in the use of three-phase squirrel-cage induction motors (IMs), there is a need for not only increasing the efficiency but also reducing the cost of the IMs. The stator winding structure of typical IMs is the distributed winding, and the length of coil end on the IMs relatively increases as the output and number of poles decrease. If a concentrated winding (CW) structure is used, the cost will reduce owing to shorter coil ends. However, the characteristics of CW-IM worsen because of the influence of magnetomotive force harmonics. In this study, we investigated the CW-IM, and determined that CW is effective in two-pole small IMs, and thus developed a trial CW-IM. This paper discusses about the effects of the stator core shapes on the characteristics of the CW-IM and describe the characteristics of trial CW-IM. The results show that the stator teeth and yoke width must be appropriately sized, the amount of copper and axial length could be reduced with CW, and an abnormal torque is occurred. With regard to abnormal torque, the use of a rotor with appropriate skewed slots is propose to be effective. © 2020 The Institute of Electrical Engineers of Japan.
引用
收藏
页码：571 / 579
页数：8
相关论文
共 25 条
  • [1] (2015)
  • [2] Low-voltage three-phase squirrel-cage induction motors-Low-voltage top runner motor, (2014)
  • [3] The Journal of the Institute of Electrical Engineers of Japan, 137, 5, (2017)
  • [4] (2007)
  • [5] Koharagi H., Sasaki M., Senoh M., Noma K., Investigation of Brush-less DC Motors with Concentrated Windings for Air Conditioners, The Paper of Technical Meeting on Rotating Machinery, (2001)
  • [6] Aizawa T., Ohno T., Sawa K., A Study on Design of Switched Reluctance Motor, The Papers of Technical Meeting on Rotating Machinery, (1992)
  • [7] Nishimura S., Satou M., Morishita M., Investigation for Practical Use of φ48 Small Capacitor Induction Motor with 2-pole Stator-Core Adopted the method to Divide into 8 Parts, The Papers of Technical Meeting on Rotating Machinery, (2004)
  • [8] The Transactions of The Institute of Electrical Engineers of Japan, 100B, 9, pp. 549-556, (1980)
  • [9] Matsui H., Sakamoto T., Nagasaka N., Experimental Results of the Induction Motor with Nonlap Concentrating Windings, The Paper of Technical Meeting on Linear Drive, IEEJ, (1992)
  • [10] Suzuki M., Sakai K., High Performance and Pole Change for Induction Motor, 2016 IEE Japan Industry Applications Society Conference, 3-12
123