Validation of a GPS-based vehicle mobility power model

被引：0

作者：

Bozdech G. ^{[1
]}

Ayers P. ^{[1
]}

Irick D. ^{[2
]}

机构：

[1] Department of Biosystems Engineering and Soil Science, University of Tennessee, 2506 E.J. Chapman Drive, Knoxville, 37996, TN

[2] Department of Mechanical, Aerospace, and Biomedical Engineering, University of Tennessee, 1512 Middle Drive, Knoxville, 37996, TN

来源：

| 2019年 / 5卷 / 04期

关键词：

CAN; Controller area network; Duty cycle; Global positioning system; GPS; Military vehicle; Mobility; Model; Power; Testing; Validation;

D O I：

10.1504/IJVP.2019.104084

中图分类号：

学科分类号：

摘要：

Recently, military vehicles have been equipped with hybrid, diesel-electric drives to improve fuel efficiency and stealth capabilities, and these vehicles require accurate power duty cycle estimates. A GPS-based mobility power and duty cycle model was developed and is used to predict the vehicle power requirements. The dynamic vehicle parameters needed to estimate the forces and power developed during locomotion are determined from the global positioning system (GPS) tracking data. Controlled tests were performed and the predicted mobility power values predicted from a GPS receiver were compared to the measured drivewheel power estimated from engine data transmitted on the vehicle’s controller area network (CAN). The results from the validation tests indicated that the model was reasonably accurate in predicting the average power requirements of the vehicle. Copyright © 2019 Inderscience Enterprises Ltd.

引用

页码：409 / 429

页数：20

共 16 条

[1]

Bozdech G., A GPS-Based Mobility Power Model for Military Vehicle Applications, (2012)

[2]

Brudnak M., Pozolo M., Meldrum A., Mortsfield T., Shvartsman A., Smith W., Goodell J., Holtz D., Virtual combat vehicle experimentation for duty cycle measurement, SAE Conference, (2008)

[3]

Gillespie T., Fundamentals of Vehicle Dynamics, (1992)

[4]

Gonder J., Markel T., Simpson A., Thornton M., Using GPS Travel Data to Assess the Real World Driving Energy Use of Plug-in Hybrid Electric Vehicles (PHEVs), (2007)

[5]

Haugen L., Design and Testing of A Vehicle Tracking System for Monitoring Environmental Impact at US Army Training Installations, (2002)

[6]

Jones R., McKinley G., Richmond P., Creighton D., A vehicle terrain interface, ISTVS Conference, (2007)

[7]

Jun J., Joonho J., Yoon S., Guensler R., Impacts of Acceleration Calculation Methods on Onroad Vehicle Engine Power Estimation, (2006)

[8]

Millo F., Rolando L., Andreata M., Numerical simulation for vehicle powertrain development, Numerical Analysis – Theory and Application, 1, pp. 519-540, (2011)

[9]

0183: Standard for Interfacing Marine Electronic Devices, (1995)

[10]

O'Keefe M., Simpson A., Kelly K., Pedersen D., Duty cycle characterization and evaluation towards heavy hybrid vehicle applications, SAE Paper 2007-01-0302, (2007)

← 1 2 →