Effect of water-impregnation on steam explosion of Pinus densiflora

被引：3
作者：
Jung J.Y. [1 ]
Ha S.Y. [1 ]
Yang J.-K. [1 ]
机构：
[1] Division of Environmental Forest Science and Institute of Agriculture & Life Science, Gyeongsang National University, Jinju
来源：
Journal of the Korean Wood Science and Technology | 2019年 / 47卷 / 02期
关键词：
Biorefinery; Impregnation; Pinus densiflora; Softwood; Steam explosion;
D O I：
10.5658/WOOD.2019.47.2.189
中图分类号：
学科分类号：
摘要：
This study addresses the biorefinery feedstock from Pinus densiflora. This raw material is a major tree species in the Republic of Korea; it is renewable, has cost-effective, and is readily available. In this study, steam explosion of P. densiflora was performed in a reactor at 225 °C and with 1 to 13 min reaction times with or without previous water impregnation. The combined severity factor (Ro), which is an expression relating the reaction temperature and reaction time used in the steam explosion treatment, ranged from 3.68 to 4.79. The influence of both impregnation and steam explosion conditions were investigated by examining color variations, chemical composition, and mass balance on the pretreated solids. The results showed that steam-exploded P. densiflora that was not impregnated with water exhibited significantly darker color (chroma 28.8-41.4) than water-impregnated and steam-exploded P. densiflora (chroma 18.8-37.3). The increased α–cellulose and lignin contents were detected as the severity factor increased. Furthermore, the α–cellulose and lignin contents in the non-impregnated/steam-exploded P. densiflora were higher than those in the water-impregnated/steam-exploded P. densiflora. However, the decreased holocellulose content was detected as the severity factor increased. In mass balance, the holocellulose yield from water-impregnated/steam-exploded P. densiflora was higher than that from the non-impregnated P. densiflora. © 2019, Korean Society of Wood Science Technology. All rights reserved.
引用
收藏
页码：189 / 199
页数：10
相关论文
共 38 条
  • [21] Statistical Yearbook of Forestry, (2008)
  • [22] Lee J.W., Jeffries T.W., Efficiencies of acid catalysts in the hydrolysis of lignocellulosic biomass over a range of combined severity factors, Bioresource Technology, 102, pp. 5884-5890, (2011)
  • [23] Liu C., Wyman C.E., The effect of flow rate of compressed hot water on xylan, lignin and total mass removal from corn stover, Industrial and Engineering Chemistry Research, 42, pp. 5409-5416, (2003)
  • [24] Mamers H., Menz D.N.J., Explosion pretreatment of Pinus radiata woodchips for the production of fermentation substrates, The Australasian Pulp and Paper Technical Association, 37, pp. 644-649, (1984)
  • [25] Maurya D.P., Singla A., Negi S., An overview of key pretreatment processes for biological conversion of lignocellulosic biomass to bioethanol, 3 Biotech, 5, 5, pp. 597-609, (2015)
  • [26] Mazet J.F., Couleur Et qualité Des Placages De Chene Et étude De Leur Comportement Photo-Chimique, (1988)
  • [27] Monavari S., Galbe M., Zacchi G., Impact of impregnation time and chip size on sugar yield in pretreatment of softwood for ethanol production, Bioresource Technology, 100, pp. 6312-6316, (2009)
  • [28] Obernberger I., Thek G., The Pellet Handbook – the Production and Thermal Utilization of Biomass Pellets, (2010)
  • [29] Overend R.P., Chornet E., Fractionation of Lignocellulosics by steam-aqueous pretreatments, Philosophical Transactions of the Royal Society of London, 321, pp. 523-536, (1987)
  • [30] Pierre F., Almeida G., Brito J.O., Perre P., Influence of torrefaction on some chemical and energy properties of maritime pine and pedunculate oak, Bioresources, 6, 2, pp. 1204-1218, (2011)
1234