Three-Dimensional Simulation Analysis of the Influence of Slat Structural Parameters on Slat Aerodynamic Noise

被引:0
|
作者
Wang H. [1 ]
Tian J. [1 ]
Luo W. [1 ]
机构
[1] School of Aeronaustics, Northwestern Polytechnical University, Xi'an
来源
Xibei Gongye Daxue Xuebao/Journal of Northwestern Polytechnical University | 2019年 / 37卷 / 06期
关键词
Aerodynamic noise; DDES; Flow features; Slat; Structure parameters;
D O I
10.1051/jnwpu/20193761129
中图分类号
学科分类号
摘要
Slat aerodynamic noise is one of important components of the frame noise. Adjusting the parameters of the slat structure can suppress the slat noise radiation effectively. Based on the typical multi-element airfoil 30P30N, firstly, by means of adjusting the parameters of slat structure, such as changing relative positions between slat and main airfoil and closing slat gap etc., a new slat profile is obtained; Then, based on the DDES simulation method, the characteristics of vortex distribution is analyzed for the new airfoil structure model, and the directivity and SPL of the far field noise are also investigated; Finally, through comparison analysis of the parameters, the physics of the generation of slat aerodynamic noise is discovered, and effects of slat parameters on the features of slat aerodynamic noise are also obtained. The results of the study show that the vortex strength of the flow around the slat has close relation to the source of slat noise. By means of adjusting slat position parameters and morphing of the slat's trailing edge, the vortex strength of the flow close to the slat cusp is reduced effectively, and further largely reducing the slat noise radiation, which can be achieved with preserving high lift coefficient of the airfoil. © 2019 Journal of Northwestern Polytechnical University.
引用
收藏
页码:1129 / 1137
页数:8
相关论文
共 28 条
  • [1] Dobrzynski W., Almost 40 Years of Airframe Noise Research: What Did We Achieve?, Journal of Aircraft, 47, 2, pp. 353-367, (2010)
  • [2] Li W., Review of the Mechanism and Noise Control of High-Lift Device Noise, Acta Aerodynamic Sinica, 36, 3, pp. 372-384, (2018)
  • [3] Guo Y.P., Yamamoto K.J., Stoker R.W., Component-Based Empirical Model for High-Lift System Noise Prediction, Journal of Aircraft, 40, 5, pp. 914-922, (2003)
  • [4] Pascioni K., Cattafesta L.N., Choudhari M.M., An Experimental Investigation of the 30P30N Multi-Element High-Lift Airfoil, 20th AIAA/CEAS Aeroacoustics Conference, (2014)
  • [5] Lockard D.P., Choudhari M., The Variation of Slat Noise with Mach and Reynolds Numbers, 17th AIAA/CEAS Aeroacoustics Conference, (2011)
  • [6] Chow L., Mau K., Remy H., Landing Gears and High LiftDevices Airframe Noise Research, 8th AIAA/CEAS Aeroacoustics Conference and Exhibit, (2002)
  • [7] Choudhari M.M., Lockard D.P., Macaraeg M.G., Et al., Aeroacoustic Experiments in the Langley Low-Turbulence Pressure Tunnel, (2002)
  • [8] Roger M., The Use of Amiet's Methods in Predicting the Noise from 2D High-Lift Devices, 6th Aeroacoustics Conference and Exhibit, (2000)
  • [9] Dobrzynski W., Pott-Pollenske M., Slat Noise Source Studies for Farfield Noise Prediction, 7th AIAA/CEAS Aeroacoustics Conference and Exhibit, (2001)
  • [10] Kolb A., Faulhaber P., Drobietz R., Et al., Aeroacoustic Wind Tunnel Measurements on a 2D High-Lift Configuration, AIAA Journal, (2007)