The selective laser sintering (SLS) process is used to prepare test bars from Al2O3/polymer binder powders. Finds that binder-coated Al2O3 particles formed bars that were approximately twice as strong as could be formed from mixtures of alumina and polymer binder at the same binder level and processing conditions. In mixed systems, bar strengths increased nearly in proportion to increases in polymer binder content over the 20-40 per cent volume binder range. Parts made in any particular laser scanning mode showed optimum values for strength and density as the laser energy density was systematically increased from 2-8cal/cm(2). Suggests that optima result from the counteracting influences of energy density on binder fusion and thermal degradation. The optimum energy density is mode or geometry sensitive and shifts to lower values as the laser scanning vector is reduced. Concludes that this behaviour is probably the result of the lower heat losses. Equivalently better utilization of laser energy is associated with the shorter scan vectors. Some of the SLS fabricated bars were infiltrated with colloidal alumina, fired to remove the binder, and sintered at 1,600 degrees C to achieve alumina bars with 50 per cent relative densities, interconnected porosity, and strengths between 2 and 8 MPa.
