GRAVITY SEGREGATION OF COMPLEX INTERMETALLIC COMPOUNDS IN LIQUID ALUMINUM-SILICON ALLOYS

Primary crystals of intermetallics that are rich in iron, manganese, and chromium form at temperatures above the liquidus, and because their density is higher than that of liquid aluminum, they cause gravity segregation in the melt. Segregation may occur either in the mold at slow cooling rates or in the bulk liquid in furnaces or ladles. The kinetics of settling of these intermetallic compounds in a melt of Al-12.5 pct Si having 1.2 pct Fe, 0.3 pct Mn, and 0.1 pct Cr has been studied. Sedimentation was investigated at 630 degrees C for settling times of 30, 90, and 180 minutes in an electric resistance furnace. The effect of settling time and height of melt on the volume percent, number, and size of intermetallic compounds was studied by image analysis. The volume percent of intermetallics increases with distance from the melt surface. Both the number of particles and the average size increase during sedimentation. The rate of settling varies with position in the melt due to depletion of intermetallics near the surface and an increase near the bottom. The settling velocities obtained experimentally were compared with terminal velocities calculated by Stokes' law. Good agreement was generally found. The settling speed of intermetallics reaches the terminal velocity at very short times and very close to the liquid surface. Stokes' law is therefore applicable to virtually all locations within the melt.