A COMPARISON AMONG 1-HORN, 3-HORN, AND 7-HORN FEEDS FOR A 37-BEAM MBA

A very common multiple beam antenna (MBA) configuration consists of a collimating device illuminated by an array of feeds. The collimating device is usually a reflector or a lens. The feeds are usually horn antennas with a circular aperture. The reflector is usually offset-fed to eliminate aperture blockage; the lens is center fed. The antenna's feeds are excited to produce a finite number of beams, so as to provide contiguous coverage of the field of view. The designer is forced to minimize the angular spacing between adjacent beams in order to maximize the minimum gain over the antenna's field of view. On the other hand, the feed horn's aperture gain is maximized when the feed horn spacing and its aperture diameter are equal. This results in antenna efficiency on the order of 30% when a single feed horn is excited to produce a beam. When a cluster of 3 or 7 adjacent feed horns are excited to produce a single beam, antenna efficiency can be increased to 50%. When it is tolerable, several identical antenna apertures can be used to replace a single aperture configuration. In this case, each of M apertures produces approximately N/M beams of an MBA that produces N beams. Horns producing adjacent beams do not illuminate the same aperture. This permits the use of a much larger horn aperture for a given beam spacing. This results in reduced spillover, higher gain of each beam, and increased antenna efficiency of each aperture. This paper investigates the maximization of gain for several lens antennas. It shows that antenna gain is increased as its focal length is decreased. That is, a focal length-to-diameter ratio (F/D) less than 1 is preferred.