ENVIRONMENTAL-EFFECTS OF CRANKCASE-LUBRICATION AND MIXED-LUBRICATION

被引:11
|
作者
VANDONKELAAR, P
机构
[1] Greentech Research sprl, B 2190 Essen
关键词
D O I
10.1016/0048-9697(90)90328-R
中图分类号
X [环境科学、安全科学];
学科分类号
08 ; 0830 ;
摘要
In a recent article in this journal [79 (1989) 1-23], R. Vazquez-Duhalt concludes that used motor oil is a very dangerous polluting product and that it is causing a serious environmental problem. In this article we will look at this problem by following the path of the oil through the engine and into the environment. In a crankcase-lubricated engine, contaminants such as polycyclic aromatic hydrocarbons (PAH) accumulate in the oil by a factor of up to 1000. This highly dangerous material leaves the engine in various ways, such as via particulates, oil leaks and uncontrolled oil changes, and then tends to accumulate again in the environment. By contrast, there are no such accumulation effects with a mixed-lubricated engine, which can be run on readily degradable lubricants. The application of modern mixed-lubrication systems should therefore be considered in the design and development of new engines, also for those traditionally equipped with crankcase-lubrication until now. This would solve the waste oil problem, which might well be more serious than the problems caused by gaseous exhaust emissions on which environmentalists and governments have so far been concentrating. © 1990.
引用
收藏
页码:165 / 179
页数:15
相关论文
共 50 条
  • [31] A finite-element local mesh refinement model for treating mixed-lubrication in conrod bearings
    Fatu, Aurelian
    Riche, Ingrid
    Bonneau, Dominique
    INTERNATIONAL JOURNAL OF SURFACE SCIENCE AND ENGINEERING, 2010, 4 (02) : 155 - 165
  • [32] Modeling Mixed-Lubrication of a Shoe-Floor Interface Applied to a Pin-on-Disk Apparatus
    Beschorner, Kurt
    Lovell, Michael
    Higgs, C. Fred, III
    Redfern, Mark S.
    TRIBOLOGY TRANSACTIONS, 2009, 52 (04) : 560 - 568
  • [34] Elasto-plastic contact of rough surfaces: a mixed-lubrication model for the textured surface analysis
    Meng, Xianghui
    Gu, Chunxing
    Xie, Youbai
    MECCANICA, 2017, 52 (07) : 1541 - 1559
  • [35] A MIXED-LUBRICATION MODEL FOR SHOE-FLOOR FRICTION APPLIED TO PIN-ON-DISK APPARATUS
    Beschorner, K. E.
    Lovell, M. R.
    Higgs, C. Fred, III
    Redfern, M. S.
    PROCEEDINGS OF THE STLE/ASME INTERNATIONAL JOINT TRIBOLOGY CONFERENCE 2008, 2009, : 143 - 145
  • [36] Transient response analysis of a connecting rod considering mixed-lubrication of piston in an internal combustion engine
    Meng, Fanming
    Zhang, Youyun
    Run Hua Yu Mi Feng/Lubrication Engineering, 2004, (04): : 8 - 10
  • [37] Experimental validation of a mixed-lubrication regime model for textured piston-ring-liner contacts
    Profito F.J.
    Vladescu S.-C.
    Reddyhoff T.
    DIni D.
    Profito, F.J. (fprofito@usp.br), 1600, ASTM International (06): : 112 - 129
  • [38] Theoretical and experimental investigation on local turbulence effect on mixed-lubrication journal bearing during speeding up
    Lv, Fangrui
    Zhang, Xinjie
    Ji, Cuicui
    Rao, Zhushi
    PHYSICS OF FLUIDS, 2022, 34 (11)
  • [39] Analysis of mixed-lubrication characteristics and structural optimization of marine composite liner stern bearing with inclined journal
    Lü F.
    Rao Z.
    Wang J.
    Zhendong yu Chongji/Journal of Vibration and Shock, 2022, 41 (19): : 22 - 29
  • [40] Influence of Mixed-Lubrication and Rough Elastic-Plastic Contact on the Performance of Small Fluid Film Bearings
    Dobrica, Mihai B.
    Fillon, Michel
    Maspeyrot, Patrick
    TRIBOLOGY TRANSACTIONS, 2008, 51 (06) : 699 - 717