PERFORMANCE OF AN INDUCTION COIL LAUNCHER

被引:36
作者
SHOKAIR, IR
COWAN, M
KAYE, RJ
MARDER, BM
机构
[1] Sandia National Laboratories, Albuquerque
关键词
D O I
10.1109/20.364640
中图分类号
TM [电工技术]; TN [电子技术、通信技术];
学科分类号
0808 ; 0809 ;
摘要
Performance of an electromagnetic induction launcher is considered for three types of armatures. These are: solid, 1-element wound and 16-element wound aluminum armatures. The one element wound armature has uniform current density throughout and thus can withstand field reversal (working against embedded armature flux) and still maintain low temperature. Slingshot simulations were performed for several configurations. Best performance was obtained for a single element wound armature with two field reversals. For a 60 kg projectile, 10.5 cm coil inner radius and 5.5 cm coil build, the velocity after 50 meters of launcher length (670 stages) exceeded 3.5 km/sec with an overall efficiency of about 45%. For the same parameters the solid and 16-element wound armatures reach a velocity of about 3.3 km/sec after 800 stages (60 meters of launcher length) but without field reversal. A velocity of 3.5 km/ sec is possible after 60 meters of launcher length with the 16-element wound armature with one field reversal, but the temperature is close to the melting temperature of aluminum. In all simulations with a solid armature, melting of some of the surface material occurs. However, it is shown that most of the melting occurs after contribution has been made to the forward going pressure, that is, melting does not affect the electrical performance of the launcher. The effect of coil firing time jitter on launcher performance is also considered and is found to be very small for realistic perturbations. For +/- 2 mu-secs random jitter, the reduction in the final velocity for a 60 meter launcher with a solid armature is less than 0.1% and the increase in temperature is only 2%. This holds for all types of armatures.
引用
收藏
页码:510 / 515
页数:6
相关论文
共 5 条
[1]  
COWAN M, 1991, IEEE T MAGNETICS, V27
[2]  
Grover F., 1946, INDUCTANCE CALCULATI
[3]  
KAYE RJ, 1991, IEEE T MAGNETICS, V27
[4]  
SHOKAIR IR, 1992, SENSITIVITY COIL LAU
[5]  
WIDNER MM, 1991, IEEE T MAGNETICS, V27