DEEP DRAWING WITH A FLUID PRESSURE ASSISTED BLANKHOLDER

被引：10
作者：
YOSSIFON, S
TIROSH, J
机构：
[1] Faculty of Mechanical Engineering, Technion, Haifa
来源：
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE | 1992年 / 206卷 / 04期
关键词：
D O I：
10.1243/PIME_PROC_1992_206_081_02
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
The feasibility of replacing the rigid blankholder in the conventional deep drawing process with a 'soft' hydrostatic fluid pressure is examined. The recommended fluid pressure range (the 'working zone') which guarantees a sound product in different circumstances is presented. The locus curve for possible failure by wrinkling of the flange and the locus curve for possible ductile rupture along the wall provide the lower and the upper limits respectively of the 'working zone'. These loci are found by a systematic series of deep drawing tests with different constant fluid pressure blankholders for three kinds of materials (copper, aluminium and stainless steel) at various thicknesses and friction conditions. The influence of the friction coefficient, the drawing ratio and the workpiece wall thickness on the blankholder fluid pressure needed to suppress flange wrinkling becomes evident experimentally.
引用
收藏
页码：247 / 252
页数：6
相关论文
共 13 条
  • [1] Yossifon S., Tirosh J., Cochavi E., On suppression of plastic wrinkling in hydroforming processes, Int. J. Mech. Sci, 26, (1984)
  • [2] Yossifon S., Tirosh J., Rupture instability in hydroforming deep drawing process, Int. J. Mech. Sci, 27, (1985)
  • [3] Yossifon S., Tirosh J., On the permissible fluid-pressure path in hydroforming deep drawing processes analysis of failure and experiments, Trans. ASME, J. Engng Industry, 110, (1988)
  • [4] Yossifon S., Tirosh J., The maximum drawing ratio in hydro- forming deep drawing processes, Trans. ASME, J. Engng Industry, 112, (1990)
  • [5] Yossifon A., Tirosh J., Buckling prevention by lateral fluid pressure in deep-drawing, Int. J. Mech. Sci, 27, (1985)
  • [6] Senior B.W., Flange wrinkling in deep drawing operation, J. Mech. Phys. Solids, 4, pp. 235-246, (1956)
  • [7] Fuchs F.J., Hydrostatic pressure: its role in metal forming, Mech. Engng, 86, (1966)
  • [8] Triantafyllidis N., Needleman A., An analysis of wrinkling at the Swift cup test, Trans. ASME, J. Engng Mater, 102, (1980)
  • [9] Chung S.Y., Swift H.W., Cup drawing from a flat blank. Part I. Experimental investigation. Part II. Analytical investigation, Proc. lnstn Mech. Engrs, 165, (1951)
  • [10] Woo D.M., The analysis of axisymmetric forming of sheet metal and the hydrostation bulging process, Int. J. Mech. Sci, 6, (1964)
12