Effect of Aluminium Content on the Tensile Properties of Mg-Al-Zn Alloys

被引：0

作者：

Latif, N. Abdul ^{[1
]}

Sajuri, Z. ^{[1
]}

Syarif, J. ^{[1
]}

机构：

[1] Univ Kebangsaan Malaysia, Fac Engn & Built Environm, Dept Mech & Mat Engn, Ukm Bangi 43600, Selangor De, Malaysia

来源：

JURNAL KEJURUTERAAN | 2014年 / 26卷

关键词：

Magnesium alloys; aluminium content; microstructure; tensile properties; work hardening;

D O I：

暂无

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

The aim of this study is to investigate the effect of aluminium content on microstructure, tensile properties and work hardenability of Mg-Al-Zn alloys. Two types of magnesium alloys were investigated i.e. AZ31 and AZ61, where the aluminium contents were 3% and 6%, respectively. Microstructure observation revealed that higher aluminium content decreases the grain size and increases the volume of Mg(17)Al(12)precipitations. From the tensile test, AZ61 demonstrated higher yield stress and tensile strength while maintaining the elongation as compared to AZ31. The work hardening rate for AZ61 was also greater as compared to that of AZ31.

引用

页码：35 / 39

页数：5

共 13 条

[11] Sajuri Z., 2005, STUDY FATIGUE BEHAV
[12] Grain refinement of magnesium alloys
StJohn, DH
Qian, M
Easton, MA
Cao, P
Hildebrand, Z
[J]. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2005, 36A (07): : 1669 - 1679
[13] The effect of twinning on the work-hardening behavior and microstructural evolution of hafnium
Yablinsky, CA
Cerreta, EK
Gray, GT
Brown, DW
Vogel, SC
[J]. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2006, 37A (06): : 1907 - 1915

← 1 2 →