Optical fibre sensors for process tomography

被引：22
作者：
Green, RG
Horbury, NM
Rahim, RA
Dickin, FJ
Naylor, BD
Pridmore, TP
机构：
[1] UNIV TEKNOL JOHOR BAHRU, FAC ELECT ENGN, DEPT CONTROL, JOHOR BAHRU, MALAYSIA
[2] UMIST, DEPT ELECT ENGN, PROC TOMOG UNIV, MANCHESTER M60 1QD, LANCS, ENGLAND
来源：
MEASUREMENT SCIENCE AND TECHNOLOGY | 1995年 / 6卷 / 12期
关键词：
D O I：
10.1088/0957-0233/6/12/008
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
This paper describes an investigation into the use of an optical fibre sensor to measure the flow of pneumatically conveyed solid particles. Typical results for the mass flow rate of dry sand versus transducer output voltage are presented for a 1 mm diameter sensor fibre. The frequency bandwidth of the sensor is determined for a range of fibre diameters and compared with the calculated response obtained using spatial filtering considerations.
引用
收藏
页码：1699 / 1704
页数：6
相关论文
共 10 条
[1]  
DYKESTEEN E, 1990, P INT C BAS PRINCIPL
[2]  
GREEN RG, 1981, S FOSSIL ENERGY PROC
[3]   THE SPATIAL-FILTERING EFFECT OF CAPACITANCE TRANSDUCER ELECTRODES [J].
HAMMER, EA ;
GREEN, RG .
JOURNAL OF PHYSICS E-SCIENTIFIC INSTRUMENTS, 1983, 16 (05) :438-443
[4]   TOMOGRAPHIC IMAGING OF 2-COMPONENT FLOW USING CAPACITANCE SENSORS [J].
HUANG, SM ;
PLASKOWSKI, AB ;
XIE, CG ;
BECK, MS .
JOURNAL OF PHYSICS E-SCIENTIFIC INSTRUMENTS, 1989, 22 (03) :173-177
[5]   CONDUCTIVITY AND PERMITTIVITY IMAGES FROM AN INDUCED CURRENT ELECTRICAL-IMPEDANCE TOMOGRAPHY SYSTEM [J].
SCAIFE, JM ;
TOZER, RC ;
FREESTON, IL .
IEE PROCEEDINGS-SCIENCE MEASUREMENT AND TECHNOLOGY, 1994, 141 (05) :356-362
[6]   DEVELOPMENT AND IMPLEMENTATION OF REAL-TIME ULTRASOUND PROCESS TOMOGRAPHY USING A TRANSPUTER NETWORK [J].
WIEGAND, F ;
HOYLE, BS .
PARALLEL COMPUTING, 1991, 17 (6-7) :791-807
[7]  
Williams R.A., 1995, COAL PREP, V15, P3
[8]  
Williams R. A., 1995, PROCESS TOMOGRAPHY P, P101
[9]  
XIE CG, 1993, PROCESS TOMOGRAPHY S
[10]   VELOCITY-MEASUREMENT OF PNEUMATICALLY CONVEYED SOLIDS USING ELECTRODYNAMIC SENSORS [J].
YAN, Y ;
BYRNE, B ;
WOODHEAD, S ;
COULTHARD, J .
MEASUREMENT SCIENCE AND TECHNOLOGY, 1995, 6 (05) :515-537
1