The effect of preheating of work material on chatter during end milling of medium carbon steel performed on a vertical machining center (VMC)

被引：11

作者：

Amin, AKMN ^{[1
]}

Abdelgadir, M ^{[1
]}

机构：

[1] Int Islamic Univ Malaysia, Fac Engn, Dept Mech Engn, Kuala Lumpur 53100, Malaysia

来源：

JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME | 2003年 / 125卷 / 04期

关键词：

D O I：

10.1115/1.1596557

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

In the present work causes and after effects of chatter have been discussed and attempts have been made to control the occurrence of chatter during end milling operation conducted on a vertical machining center (VMC). Chatter has been treated as a resonance effect and preheating of the incoming work material layers using high frequency induction. heating has been tried as a method of controlling chatter It has been found that preheating results in substantial lowering down of acceleration amplitude of chatter in a wide range of cutting speed. This has facilitated low tool wear intensity, improved machined surface finish and low noise level during machining. Work material properties were practically unaffected due to low preheating temperature..

引用

页码：674 / 680

页数：7